Quadra-Fire QV32-A User Manual download pdf (Page 34)

Step 8. Wiring the Fireplace

NOTE: Electrical wiring must be installed by a licensed

electrician.

CAUTION: DISCONNECT REMOTE CONTROLS IF AB-

SENT FOR EXTENDED TIME PERIODS. THIS WILL PRE-

VENT ACCIDENTAL FIREPLACE OPERATION.

For Standing Pilot Ignition Wiring

Appliance Requirements

• This appliance DOES NOT require 110-120 VAC to operate.

WARNING: DO NOT CONNECT 110-120 VAC TO

THE GAS CONTROL VALVE OR WALL SWITCH

OR THE APPLIANCE WILL MALFUNCTION

AND THE VALVE WILL BE DESTROYED.

Figure 36. Standing Pilot Ignition Wiring Diagram

Figure 37. Fan Wiring Diagram

Optional Accessories

Optional fan and remote control kits require that 110-120

VAC be wired to the factory installed junction box before

the fireplace is permanently installed.

Wall Switch

Position the wall switch in the desired position on a wall.

Run a maximum of 25 feet (7.8 m) or less length of 18

A.W.G. minimum wire and connect it to the fireplace ON/

OFF switch pigtails.

CAUTION: LABEL ALL WIRES PRIOR TO DISCONNEC-

TION WHEN SERVICING CONTROLS. WIRING ERRORS

CAN CAUSE IMPROPER AND DANGEROUS OPERATION.

VERIFY PROPER OPERATION AFTER SERVICING.

BLACK S2

OFF

ON/OFF

SWITCH

WHITE T2

RED T1

THERMOPILE

GAS VALVE

BLACK S1

3/16” PIGGYBACK CONNECTOR

THERMOCOUPLE

REMOTE SWITCH

PIGTAIL

OPTIONAL WALL SWITCH,

THERMOSTAT OR REMOTE

FAN

TEMPERATURE

SENSOR SWITCH

SPEED CONTROL

(RHEOSTAT)

JUNCTION BOX

NOTE: IF ANY OF THE ORIGINAL WIRE

AS SUPPLIED WITH THE APPLIANCE

MUST BE REPLACED, IT MUST BE

REPLACED WITH TYPE 105 C RATED WIRE.

JUNCTION BOX

VARIABLE SPEED CONTROL

TEMPERATURE

SENSOR SWITCH

WHT

GRN

BLK

110-120 VAC

BLOWER

BLOWER RECEPTACLE

BLK

WHT

GROUND

WHT

BLK

1 2 ... 29 30 31 32 33 34 35 36 37 38 39 40 41 42

Comments to this Manuals

No comments

Quadra-Fire QV32-A User Manual Page 34

Comments to this Manuals

Related products and manuals for Unknown Quadra-Fire QV32-A