Quadra-Fire QV32-A User Manual download pdf (Page 36)

Installing the Trim

Combustible materials may be brought up to the specified

clearances on the side and top front edges of the fireplace,

but MUST NEVER overlap onto the front face. The joints

between the finished wall and the fireplace top and sides

can only be sealed with a 300° F. (149° C) minimum sealant.

WARNING: WHEN FINISHING THE FIREPLACE,

NEVER OBSTRUCT OR MODIFY THE AIR INLET/

OUTLET GRILLES IN ANY MANNER.

Install optional marble and brass trim surround kits as

desired. Marble, brass, brick, tile, or other non-combustible

materials can be used to cover up the gap between the

sheet rock and the fireplace.

Do not obstruct or modify the air inlet/outlet grilles. When

overlapping on both sides, leave enough space so that the

bottom grille can be opened and the trim door removed.

Step 10. Installing Trim, Logs and

Ember Material

Placing the Ember Material

Ember material is shipped with this gas fireplace. The bag

labeled Mystic Embers is standard glowing ember material.

To place the ember material:

• Remove the top louver by lifting it up and away from the unit.

• Unlatch the latches at the top and bottom of the glass door.

• Remove the glass door from the unit (see Figure 45).

• Place dime size pieces of ember material about 1/2 inch

apart near port holes in burner top. Do NOT press em-

bers into burner ports. Cover the top of the burner with a

single layer of ember material (see Figure 46).

• Save the remaining ember materials for use during fire-

place servicing. The bag of embers provided is sufficient

for 3 to 5 applications.

• Reinstall and latch the glass door and top louver on the unit.

Figure 46. Placement of the Ember Material

Figure 45. Glass Assembly

Positioning the Logs

If the gas logs have been factory installed they should not

need to be positioned. If the logs have been packaged

separately, refer to the instructions that accompany the

logs. Save the log instructions with this manual.

If sooting occurs, the logs might need to be repositioned

slightly to avoid excessive flame impingement.

GLASS SPECIFICATIONS:

QV36-A 24 5/8 x 35 3/8 CERAMIC

QV32-A 21 1/8 x 30 3/8 CERAMIC

EMBER MATERIALS

LATCHES

(BOTH TOP

AND BOTTOM)

GLASS

ASSEMBLY

CAUTION: THE GLASS DOOR MUST BE SECURELY

LATCHED BEFORE OPERATING THE UNIT.

___________________________________________

Shutter Settings

Model NG LP

QV32-A 3/16” SET

QV36-A 1/4” SET

Figure 43

Replace the logs referring to your manual and log instruc-

tions.

Position the right wall all the way to back wall. Secure in

position as was done in Step 2 (see Figure 44).

Figure 44

1 2 ... 31 32 33 34 35 36 37 38 39 40 41 42

Comments to this Manuals

No comments

Quadra-Fire QV32-A User Manual Page 36

Comments to this Manuals

Related products and manuals for Unknown Quadra-Fire QV32-A